Rane SSA 6, Operator'S Manual, Page: 5 / 5

Manual-5
Parameter Specification Limit Units Conditions/Comments
Power Output All Channels Driven, 20-20kHz
100 Min W (6) 8 Ohm Loads
150 Min W (6) 4 Ohm Loads
300 Min W (3) Bridged Pairs into 8 Ohms
Inputs: Active Unbalanced Gold Plated RCA Connectors
..........Impedance 20k 1% Ohms
..........Sensitivity 0.6V input=100W/8 ohms mV Level Controls at Max
Outputs:
..........Damping Factor 300:1 10% 1kHz
..........Minimum Load No Less Than 4 Ohms Single Channel Operation
No Less Than 8 Ohms Bridged Operation
Fan Cooling Continuous Variable Speed DC Intake Rear; Exhaust Front
Output Protection On/Off Transient Muting Output Relays
Input Protection Servo-Locked™ Input Atten.
..........Peak Limit 1% THD
Attenuates Input to Maintain <3% THD for
15dB of Overdrive
..........Load Limit Attenuates Input as much as -30dB to
Maintain Safe Power Dissapation—Relay
Cutout Fail-Safe
Frequency Response 10-55kHz +0/-3 dB
THD+Noise 0.07 .03 % 100W/8 Ohms, 20-20kHz
IM Distortion (SMPTE) 0.1 .05 % 60Hz/7kHz, 4:1
Signal-to-Noise Ratio 103 2 dB re 100W, 0.775v sens., 20kHz BW
Crosstalk -60 3 dB 1kHz, Any Channel to Any Channel
Maximum AC Power 2200 W (6) Channels driven to full power
UL Listed UL Complies with UL 813
CSA Certified Complies with C22.2 #1 M90
Unit: Construction All Steel
..........Size 5.25"H x 17.4"W x 11"D (3U) (13.3cm x 44.1cm x 27.9cm)
..........Weight 32 lb (14.5kg)
Shipping: Size 11" x 23" x 16" (27.9cm x 58.4cm x 40.6cm)
..........Weight 37 lb (17kg)
Note: 0dBu=0.775Vrms
BLOCK DIAGRAM