5
Features
Front Panel
1.
1/4” (6.35 mm) / XLR Combo Jacks:
Two
balanced TRS, switchable Mic / Line /
Line-Plus audio inputs are available. The
Line-Plus setting accepts unbalanced left
and right signals and sums them to mono.
24V phantom power is available for
condenser mics.
For input auto switching:
•
Connect to an XLR input and the Mic
input
will automatically be selected.
Select either Dynamic or Condenser
mode in the Halogen software.
•
Connect to a TRS input and the Line
input will automatically be
selected.
The Line or Line-plus mode can be selected in the Halogen software.
Note:
If no input connection is made, the inputs will be muted to prevent noise.
2.
1/8” (3.5 mm) Line Output:
This line output allows for connection to a mixer, speaker,
headphones, or recording device.
3.
Input LEDs:
The input LED will illuminate green when a proper signal level is detected. The
input LED will illuminate red when the signal is overloading or “clipping”.
Rear Panel
1.
RAD Port (RJ-45):
This port uses a shielded
Cat 5e cable to connect to a Rane
multiprocessor RAD port for communication
and audio transmission. The Cat 5e distance
from a multiprocessor port to the RAD22
must not be more than 300 ft. (100 m) to
prevent crosstalk.
There are two LEDs integrated into the RJ-45
jack:
•
Amber LED ON = good power
•
Amber LED OFF = faulty power
•
Green LED ON = no data errors
•
Green LED OFF = data error (check
cable)
1
1
2
3
3
1
