Command reference
R&S
®
ZNL/ZNLE
685
User Manual 1178.5966.02 ─ 19
Example:
Suppose that the active channel setup contains traces Trc1 and
Trc2, assigned to channels no. 1 and 2, respectively.
:CALC2:PAR:SEL 'TRC2'; :CALC2:MARK1 ON; MARK2
ON
Select Trc2 as the active trace of channel 2 and activate mark-
ers 1 and 2 for it. The default position for both markers is the
center of the sweep range.
INSTrument:NSELect 2
Make channel 2 the active channel.
CALCulate:MARKer:COUPled:TYPE ALL
Select coupling type "All" (channel setup-wide coupling).
CALC:MARK:COUP ON
Activate marker coupling to Trc2 (the active trace of the active
channel). Automatically creates markers no. 1 and 2 on Trc1
and couples them to the respective markers of Trc2.
Manual operation:
See
CALCulate:MARKer:COUPled:TYPE
<Type>
Selects the marker coupling type to be used in the current channel setup.
Marker coupling is enabled using
CALCulate:MARKer:COUPled[:STATe] ON
Changing the coupling type automatically disables marker coupling throughout the
channel setup.
Parameters:
<Type>
ALL | CHANnel | DIAGram
Marker coupling mode
ALL
channel setup-wide
CHANnel
channel-wide
DIAGram
diagram-wide
Example:
See
CALCulate:MARKer:COUPled[:STATe]
Manual operation:
See
CALCulate<Chn>:MARKer:DEFault:FORMat
<OutFormat>
Defines the default marker format of the selected channel's active trace.
New markers will be formatted with the default marker format; previously existing mark-
ers will be reformatted if (and only if) their marker format is set to (Trace)
DEFault
CALCulate<Chn>:MARKer<Mk>:FORMat
).
Suffix:
<Chn>
.
Channel number used to identify the active trace
VNA command reference
