Preparing for Use
R&S
®
ZNH
16
Getting Started 1334.5979.02 ─ 03
– The maximum consumption of electronic devices
– The self-discharge of the battery - the higher the state of charge, the
higher the rate of self-discharge
●
Avoid a deep discharge of the battery. A deep discharge occurs when the
state of charge falls below 5% of the battery's capacity.
●
Recharge the battery at least every six months.
Should the battery voltage be low or even 0 V, the battery protection circuit may
have gone into a sleep mode. In that case, reset the battery with an approved
charger.
3.1.6.3
Transportation
No special regulations apply for transporting the battery. The battery cells contain
no metallic lithium.
3.1.6.4
End of Life
The capacity of the battery decreases after it has gone through numerous charge
cycles and nearing its end of life. When the battery is dead, do not open the bat-
tery. Do not dispose battery in fire.
3.2
Switching the Instrument On and Off
The instrument can be powered with an AC or DC (battery operated or via car
adapter) input. See
Chapter 3.1.4, "Using the AC Adapter"
► Press [Power] key to switch on the instrument.
During booting, the R&S
ZNH displays a splash screen to indicate the opera-
ble frequency range of the instrument. Depending on the frequency upgrade
option installed, the respective splash screen is loaded.
After booting, the instrument is ready for operation.
Refer to the instrument brochure for the list of options available.
► Press [Power] key to switch off the instrument.
Switching the Instrument On and Off
www.allice.de
Allice Messtechnik GmbH
