R&S SMJ100A, Operating Manual

Page: 643 / 874

Remote Control Commands
R&S
®
SMJ100A
627 Operating Manual 1403.7458.32 ─ 14
Example: MMEM:CDIR 'D:\user\waveform'
sets the default directory.
BB:ARB:WSEG:NEXT 2
selects segment 2 to be output.
BB:ARB:TRIG:SMOD NEXT
selects extended trigger mode next, i.e. the segment specified
with command
:BB:ARB:WSEG:NEXT
will be output.
BB:ARB:SEQ AUTO
selects trigger mode Auto.
BB:ARB:WAV:SEL 'multi_wv1'
loads multi segment waveform
multi_wv1.wv
. Generation of
segment 2 starts.
BB:ARB:WSEG:NEXT 3
switched at once to output of segment 3.
Manual operation: See "Next Segment" on page 382
[:SOURce<hw>]:BB:ARBitrary:WSEGment:NEXT:EXECute
Triggers manually switchover to the subsequent segment in the mutli segment file. A
manual trigger can be executed only when an internal next segment source
(
BB:ARB:WSEG:NEXT:SOUR INT
) has been selected.
To perform a switchover to any segment within the multi segment file, select the next
segment with the command
BB:ARB:WSEG:NEXT
.
This command is disabled, if a sequencing play list is enabled.
Example: BB:ARB:WSEG:NEXT:SOUR INT
selects internal next segment source.
BB:ARB:WSEG:NEXT 2
selects segment 2 to be output.
BB:ARB:WSEG:NEXT:EXEC
executes a switchover to the next segment.
Usage: Event
Manual operation: See "Execute Next Segment" on page 388
[:SOURce<hw>]:BB:ARBitrary:WSEGment:NEXT:SOURce?
Queries the next segment source.
Return values:
<Source> INTernal
*RST:
INTernal
Example: BB:ARB:WSEG:NEXT:SOUR?
queries the next segment source.
Usage: Query only
Manual operation: See "Next Segment Source" on page 387
SOURce Subsystem