R&S SMJ100A, Operating Manual

Page: 575 / 874

Remote Control Commands
R&S
®
SMJ100A
559 Operating Manual 1403.7458.32 ─ 14
:SENSe<ch>[:POWer]:OFFSet
........................................................................................ 565
:SENSe<ch>[:POWer]:OFFSet:STATe
............................................................................. 565
SENSe<ch>[:POWer]:SNUMber?
.................................................................................... 565
:SENSe<ch>[:POWer]:SOURce
.......................................................................................566
SENSe<ch>[:POWer]:STATus[:DEVice]?
......................................................................... 566
SENSe<ch>[:POWer]:SVERsion?
....................................................................................566
SENSe<ch>[:POWer]:TYPE?
..........................................................................................567
:SENSe<ch>[:POWer]:ZERO
.......................................................................................... 567
:SENSe<ch>:UNIT[:POWer]
............................................................................................567
:SENSe<ch>[:POWer]:APERture:DEFault:STATe <UseDefAp>
Deactivates the default aperture time of the respective sensor.
To specify a user-defined value, use the command
:SENSe<ch>[:POWer]:
APERture:TIMe
on page 559.
Parameters:
<UseDefAp> 0 | 1 | OFF | ON
*RST:
1
Example: SENS:POW:APER:DEF:STAT 0
deactivates the default aperture time of the sensor.
Manual operation: See "Use Default Aperture Time" on page 239
:SENSe<ch>[:POWer]:APERture:TIMe <ApTime>
Defines the aperture time (size of the acquisition interval) for the corresponding sensor.
Parameters:
<ApTime> float
Range:
depends on connected power sensor to depends
on connected power sensor
Increment: 1E-9
*RST:
depends on connected power sensor
Example: SENS:POW:APER:TIM 23ms
sets 23 ms aperture time.
Manual operation: See "Aperture Time" on page 239
:INITiate<ch>[:POWer]:CONTinuous <Continuous>
The command switches the local state of the continuous power measurement by the
R&S NRP-Zxx power sensors on and off. Switching the local state off enhances the
measurement performance during remote control
The remote measurement is triggered by the READ query (command
:READ<ch>[:
POWer]?
on page 560) which also provides the measurement results. The local
state is not influenced by this command, measurements results can be retrieved with
local state on or off.
SENSe, READ and INITiate Subsystems