Remote Control Commands
R&S
®
SMA100B
348
User Manual 1178.3834.02 ─ 03
:OUTPut:ALL[:STATe]
<State>
Activates all RF output signals of the instrument.
Parameters:
<State>
0 | 1 | OFF | ON
*RST:
n.a. (factory preset: 0)
Example:
OUTP:ALL OFF
switches off all RF output signals.
:OUTPut<hw>[:STATe]
<State>
Activates the RF output signal.
Parameters:
<State>
0 | 1 | OFF | ON
*RST:
0
Example:
OUTP ON
Activates the RF output.
Manual operation:
See
:OUTPut<hw>[:STATe]:PON
<Pon>
Defines the state of the RF output signal when the instrument is switched on.
Parameters:
<Pon>
OFF | UNCHanged
*RST:
n.a. (factory preset: UNCHanged)
Example:
OUTP:PON OFF
The RF output is deactivated when the instrument is switched
on.
Manual operation:
See
:OUTPut<hw>:AMODe
<AMode>
Sets the attenuator mode at the RF output.
OUTPut Subsystem