Activation
1GP71_0E
13
Rohde & Schwarz
Possible values for the emulation language depend on the signal generator
familiy.
Emulation language
SMA100
SMB100
SMF100
AF2040
X
AN680XX
X
HP8340
X
HP8360
X
HP8373
X
HP8643
X
X
HP8648
X
HP8657
X
HP8662
X
RC3102
X
Table 5: Emulation modes on SM*
“SCPI” returns to the instrument specific SCPI command set.
Remote
Use the command notation
“
SYSTem:LANGuage <value>
” to select the appropriate language emulation
mode.
Upper-case and lower-case notation serves to distinguish between the long
and the short form. The instrument itself does not distinguish between upper-
case and lower-case spelling.
Possible values are shown in table “Emulation modes on SM*”.
Power down / Power up
The selected language emulation mode is saved when the instrument is
switched off.
The emulation parameters are
NOT
persistent and are therefore lost when the
instrument is switched off.
When the instrument is switched on again, it starts up with the language
emulation mode, which was active before switching it off.
Due to the loss of the emulation parameters, it is strongly recommended to
preset the instrument by applying the corresponding preset command, e.g., the
command IP in HP8340 emulation mode.
