Remote Control Commands
R&S
®
SGT100A
326
User Manual 1176.8674.02 ─ 07
Note:
Instruments with Linux operating system ignore this command, since Linux does
not use drive letter assignment.
Usage:
SCPI confirmed
:MMEMory:RDIRectory
<Directory>
Removes an existing directory from the mass memory storage system. If no directory
is specified, the subdirectory with the specified name is deleted in the default directory.
Setting parameters:
<Directory>
string
String parameter to specify the directory to be deleted.
Usage:
Event
:MMEMory:STORe:STATe
<savrcl_state_nr>, <file_name>
Stores the current instrument setting in the specified file.
The instrument setting must first be stored in an internal memory with the same num-
ber using the common command
*SAV
.
Setting parameters:
<savrcl_state_nr>
Corresponds to the specific
<number>
defined with the
*SAV
command, e.g.
*SAV 4
.
<file_name>
String parameter to specify the file name with extension
*.savrcltxt
.
Usage:
Event
11.10 Fast Speed Commands
This section describes special commands that allow a fast frequency and level setting.
:FFASt
<Freq>
Special command to set the RF output frequency with minimum latency. No unit (e.g.
Hz) allowed.
Bypasses the status system so command
*OPC?
cannot be appended.
Parameters:
<Freq>
float
Example:
FFASt 12750000000
Fast Speed Commands
