Protocol analysis
R&S
®
RTO6
869
User Manual 1801.6687.02 ─ 05
"Max"
Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
Remote command:
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:DOPerator
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:DMAX
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:DMIN
Data BitState
Defines the bit state to be checked for the selected field. Permitted bit states are "1",
"0" or "X" (do not care).
Remote command:
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:BIT
Index
Defines for the selected field, how an index check is executed.
"Condition"
Defining a specific index or an index range requires to set the opera-
tor to one of the following conditions: equal, in range.
"Min"
Specifies the index or sets the start value of an index range.
"Max"
Sets the the end value of an index range, if "Condition" is set to
INRange
.
Remote command:
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:IOPerator
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:IMAX
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:IMIN
13.22.3.2
Triggering on USBPD
Prerequisite: A bus is configured for the USBPD signal to be analyzed.
In order to be able to trigger on an USBPD data, the "Show decode detail" field in the
"Configuration" tab of the protocol setup should be disabled.
For the basic trigger settings, proceed in the following way:
1. Press the [Bus] key and selet the "Shortcuts" tab.
2. Press "Setup trigger".
3. Tap the "Source" button and select the "Serial bus" trigger source.
4. Tap "Serial bus" and select the serial bus that is set to USBPD.
USBPD (option R&S
RTO6-K570)