R&S RTO6, User Manual

Page: 322 / 2677

Measurements
R&S
®
RTO6
322 User Manual 1801.6687.02 ─ 05
If further settings are available for a measurement, a settings icon is shown beside the
measurement's name in the "Active measurements" list. Tap the icon to configure the
measurement.
Figure 8-7: Selected active measurements, some have further settings
Figure 8-8: Settings for cycle area measurement
This chapter explains all settings for amplitude/time measurements. For a description
of available measurement, see
Chapter 8.2.5.1, "Overview of amplitude/time measure-
ments" , on page 316.
Signal threshold .......................................................................................................... 322
Area level .................................................................................................................... 322
Pulses slope ................................................................................................................323
Measured slope ...........................................................................................................323
Settings for delay and phase measurements (analog sources) .................................. 323
Settings for delay and phase measurements (digital sources) ................................... 324
Setup/Hold measurement settings .............................................................................. 324
Clock ref level ..............................................................................................................325
Ref level ...................................................................................................................... 326
Pulse count ................................................................................................................. 326
Edges slope ................................................................................................................ 326
Delay to trigger measurement settings ....................................................................... 326
Signal threshold
Defines a signal value that must be exceeded for the signal value to be included in the
measurement. The setting is relevant for area, time, and counting measurements.
Remote command:
MEASurement<m>:DETThreshold
on page 1493
Area level
The reference level used to integrate the waveform. The setting is only relevant for
area measurements.
Remote command:
MEASurement<m>:AMPTime:ALEVel
on page 1493
Automatic measurements