Remote control commands
R&S
®
RTO6
2434
User Manual 1801.6687.02 ─ 05
Parameters:
<Slope>
POSitive | NEGative | EITHer
*RST:
POSitive
Usage:
Asynchronous command
24.18.4.3
Width trigger
See also:
●
TRIGger<m>:PARallel:WIDTh:EXPRession[:DEFine]
TRIGger<m>:PARallel:WIDTh:POLarity
..........................................................................2434
TRIGger<m>:PARallel:WIDTh:RANGe
........................................................................... 2434
TRIGger<m>:PARallel:WIDTh:WIDTh
............................................................................ 2434
TRIGger<m>:PARallel:WIDTh:DELTa
.............................................................................2435
TRIGger<m>:PARallel:WIDTh:POLarity
<Polarity>
Sets the polarity of a pulse. When triggering on a positive pulse, the trigger event
occurs on the high to low transition of the pulse if the timing condition is true. When
triggering on a negative pulse, the trigger event occurs on the low to high transition of
the pulse if the timing condition is true.
Parameters:
<Polarity>
POSitive | NEGative | EITHer
*RST:
POSitive
Usage:
Asynchronous command
TRIGger<m>:PARallel:WIDTh:RANGe
<RangeMode>
Selects how the range of a pulse width is defined:
Parameters:
<RangeMode>
WITHin | OUTSide | SHORter | LONGer
WITHin | OUTSide
Pulses inside or outside a given time range. The time range
Width
±
Delta
is defined by
TRIGger<m>:PARallel:WIDTh:DELTa
.
SHORter | LONGer
Pulses shorter or longer than a given width defined by
TRIGger<m>:PARallel:WIDTh:WIDTh
*RST:
WITHin
Usage:
Asynchronous command
TRIGger<m>:PARallel:WIDTh:WIDTh
<Width>
Sets the limit for the pulse width.
Mixed signal option (MSO, R&S
RTO6-B1)
