Remote control commands
R&S
®
RTO6
1293
User Manual 1801.6687.02 ─ 05
REAL,32
The data is stored as binary data (Definite Length Block Data
according to IEEE 488.2). Each waveform value is formatted in
32-Bit IEEE 754 Floating Point Format.
The schema of the result string is as follows:
#41024<value1><value2>…<value n>
with:
#4
= number of digits (= 4 in the example) of the following num-
ber
1024
= number of following data bytes (= 1024 in the example)
<value>
= 4-byte floating point values
For large data (
≥
1
GB), the result string starts with "#(data
length)". The number inside the parentheses indicates the real
data length in bytes.
INT,8 | INT,16
Signed integer data with length 8 bit or 16 bit. It defines that
CHANnel<m>[:WAVeform<n>]:DATA[:VALues]?
returns the
raw sample data of the ADC as integers. If format of the wave-
form data differs from the defined export format, the instrument
converts the data to the required length.
The result string has the same schema as the REAL format.
Fot INT,16 you can set the byte order using the
Data conversion is described in
on page 461.
For digital channel data, math and histogram data, INT formats
are not available.
OFF
.
*RST:
ASCii
Example:
FORMat:DATA REAL,32
FORMat:DATA?
REAL,32
Usage:
SCPI confirmed
FORMat:BORDer
<ByteOrder>
Sets the endianess.
The command is only relevant for raw data export in high definition mode (16 bit word
length).
Parameters:
<ByteOrder>
LSBFirst | MSBFirst
LSB first: little endian, least significant byte first
MSB first: big endian, most significant byte first
*RST:
LSBFirst
Usage:
Asynchronous command
General remote settings