R&S NRP2, User Manual

Page: 266 / 437

Remote Control - Commands
R&S
®
NRP2
248 User Manual 1173.9157.02 ─ 03
MEMory:
​
TABLe:
​
DATA:
​
POINts?
​
.......................................................................................251
MEMory:
​
TABLe:
​
FREQuency
​ ...........................................................................................251
MEMory:
​
TABLe:
​
FREQuency:
​
POINts?
​ ..............................................................................251
MEMory:
​
TABLe:
​
GAIN[:
​
MAGNitude]
​ .................................................................................251
MEMory:
​
TABLe:
​
GAIN:
​
POINts?
​
.......................................................................................252
MEMory:
​
TABLe:
​
MAP
​
.....................................................................................................252
MEMory:
​
TABLe:
​
MOVE
​
...................................................................................................252
MEMory:
​
TABLe:
​
RESet
​
...................................................................................................252
MEMory:
​
TABLe:
​
SELect
​
..................................................................................................252
MEMory:CATalog[:ALL]?
Lists the names of all stored device states and correction tables. The length of the
response depends on how many device states and tables are stored.
Return values:
<NR1>, <NR1>
{,"<string>"} The first two values denote the length in bytes of the occupied
RAM and of the RAM still available for storing states and tables.
These values are followed by a string for each stored state and
then for each stored table; this string again consists of two strings
and a numeric value:
<string>, <type>, <NR1>
<string> gives the name of the stored data item,
<type>
the type
(TABL or STAT) and
<NR1>
the length of the data item in bytes.
Example: The response to query
MEM:CAT?
could be:
956,99044,"REFL,STAT,408","NRPZ21,TABL,
432","SPLITTER1,TABL,116"
Usage: Query only
MEMory:CATalog:STATe?
Only gives a list of stored device states and is otherwise identical with
MEMory:CATalog[:ALL]?
.
Usage: Query only
MEMory:CATalog:TABLe?
Only gives a list of stored correction tables and is otherwise identical with
MEMory:CATalog[:ALL]?
.
Usage: Query only
MEMory:CLEar[:NAME] <name>
Clears the content of the correction table or the stored device state with the designation
<name>
. The table is maintained but does not contain entries.
Notice: Possible data loss
MEMory