R&S NRP2, User Manual

Page: 265 / 437

Remote Control - Commands
R&S
®
NRP2
247 User Manual 1173.9157.02 ─ 03
Parameters:
<type> ASCii | REAL
*RST:
ASCii
FORMat:SREGister <format>
Specifies wich format s used for the return value of *STB?.
Parameters:
<format> ASCii | BINary | HEXadecimal | OCTal
*RST:
ASCii
6.9 MEMory
The MEMory system is used for storing device states (
:STATe
) and correction tables
(
:TABLe
).
:STATe To allow a rapid and convenient changeover between device setups for different appli-
cations, up to 20 setups can be stored in the device. The setup with the number 0 is
the default setup made in the factory. This setup can neither be changed nor cleared.
:TABLe Tables can be stored for a frequency-dependent correction of measured values. Up to
10 tables with two columns and up to 80 entries (lines) can be created. Thus, not only
the sensors but also the frequency response of various test assemblies can be com-
pensated for during the measurement.
The tables are selected with
​
[SENSe<[1]..4>]:
​
CORRection:
​
FDOTable[:
​
SELect]
​
on page 267 and then activated and deactivated with
​
[SENSe<[1]..4>]:
​
CORRection:
​
FDOTable:
​
STATe
​
on page 267.
Names can be assigned to the tables. Some commands which do not specify a table
name affect the table currently selected with
​
MEMory:
​
TABLe:
​
SELect
​
on page 252.
Stored data is not affected by an
*RST
command.
MEMory:
​
CATalog[:
​
ALL]?
​
................................................................................................248
MEMory:
​
CATalog:
​
STATe?
​
..............................................................................................248
MEMory:
​
CATalog:
​
TABLe?
​ ..............................................................................................248
MEMory:
​
CLEar[:
​
NAME]
​ ..................................................................................................248
MEMory:
​
CLEar:
​
TABLe
​ ...................................................................................................249
MEMory:
​
FREE[:
​
ALL]?
​
....................................................................................................249
MEMory:
​
FREE:
​
STATe?
​
..................................................................................................249
MEMory:
​
FREE:
​
TABLe?
​
..................................................................................................249
MEMory:
​
NSTates?
​
.........................................................................................................249
MEMory:
​
STATe:
​
CATalog?
​ ..............................................................................................249
MEMory:
​
STATe:
​
DEFine
​ ..................................................................................................250
MEMory:
​
STATe:
​
MAP
​ .....................................................................................................250
MEMory:
​
STATe:
​
RESet?
​
.................................................................................................250
MEMory:
​
TABLe:
​
DATA?
​
..................................................................................................250
MEMory