Remote Control Commands
R&S
®
NGL200/NGM200
136
User Manual 1178.8736.02 ─ 06
*RST:
0
Example:
INST OUT1
VOLT:RAMP ON
VOLT:RAMP?
-> 1
EasyRamp function of Ch1 is activated
[SOURce:]VOLTage:RAMP:DURation
<duration>
[SOURce:]VOLTage:RAMP:DURation?
Sets or queries the duration of the voltage ramp.
Parameters:
<duration>
numeric | MIN | MAX | DEFault
numeric
Duration of the ramp function in seconds.
MIN
Minimum duration of the ramp function at 0.00 s.
MAX
Minimum duration of the ramp function at 10 s.
DEF
Default duration of the ramp function at 0.01 s.
Range:
0.01 to 10.00
*RST:
0.01
Default unit: s
Example:
VOLT:RAMP:DUR 4
VOLT:RAMP:DUR?
-> 4
Duration of the ramp function is set at 4 s.
7.7.3
Digital I/O
The
DIO
subsystem contains the commands for configuring a Digital I/O function for
the output channels.
DIO:FAULt:CHANnel
<arg0>
Sets or queries channel selection for the digital output fault source.
.
Parameters:
<arg0>
1 | 2
Advanced Operating Commands
