R&S NGL200 series, User Manual

Page: 30 / 150

Operating Basics
R&S
®
NGL200
27 User Manual 1178.8736.02 ─ 02.01
Device status bar
Function Description
GPIB/IEEE488 interface If GPIB/IEEE488 interface is installed, the icon is
highlighted in white.
SCPI command If active, the icon is highlighted in white.
If an error is in the remote command, the icon is
highlighted in red.
See Chapter 7, "Remote Control Commands" ,
on page 79.
USB host interface If USB stick is present, the icon is highlighted in
white.
Data Logger If data logging is present, the icon is highlighted in
white.
If an error is present, the icon is highlighted in red.
See Chapter 6.7, "Data Logger" , on page 61.
USB device interface If a host command is received in USB interface, the
icon is highlighted in white.
Ethernet/LAN interface If active, the icon is highlighted in white.
See Chapter 6.10, "Interfaces" , on page 67.
Time Display of time in hh:mm:ss format.
See Chapter 6.11.4, "Date and Time" , on page 76.
Touchscreen If disabled, the icon is highlighted in white.
See Chapter 5.2, "Using the Touchscreen" ,
on page 30.
Channel status bar
Function Description
Channel number Indication of channel 1 or channel 2 display.
Operation mode The R&S NGL200 has three operating modes:
●
CV: Constant voltage mode
●
CC: Constant current mode
●
CR: Constant resistance mode. The
R&S
NGL200 goes into this mode when oper-
ates in sink mode and the "Constant Resist-
ance" mode is activated.
For more information, see Chapter 5.5, "Output
Modes" , on page 37.
"Over Current Protection" (OCP),
If enabled, the icon is highlighted in white.
If triggered, the icon blinks.
See Chapter 6.3.1, "Over Current Protection
(OCP)" , on page 45.
Display Overview