Welcome to the MSRA operating mode
R&S
®
FSWP-B1
12
User Manual 1177.5862.02 ─ 09
2. Select the "Multi Standard Radio Analyzer" tab.
3. Confirm the message informing you that you are changing operating modes.
The R&S
FSWP closes all active measurement channels in the current operating
mode, then opens a new measurement channel for the MSRA operating mode.
Note:
when you return to the Phase Noise Analyzer mode, the R&S
FSWP opens
a Spectrum channel.
In addition to the "MSRA View", an "MSRA Primary" tab is displayed.
The Sequencer is automatically activated in continuous mode (see
"Using the sequencer in MSRA mode"
on page 23), starting an I/Q Analyzer data
acquisition with the default settings (but with a "Spectrum" result display). It can be
configured in the MSRA "Overview" dialog box, which is displayed when you select
the "Overview" softkey from any menu (see
Chapter 6, "MSRA configuration"
Remote command:
INST:MODE MSR
, see
2.2
Understanding the display information
The following figure shows a screen display during MSRA operation. All different infor-
mation areas are labeled. They are explained in more detail in the following sections.
●
The orange background of the screen behind the measurement channel tabs indi-
cates that you are in MSRA operating mode.
●
The icon on the tab label indicates that the displayed trace (e.g. in an MSRA
secondary application) no longer matches the currently captured data. This may be
the case, for example, if a data acquisition was performed in another secondary
application. As soon as the result display is refreshed, the icon disappears.
●
The icon indicates that an error or warning is available for that measurement
channel. This is particularly useful if the MSRA View tab is displayed.
An orange "IQ" indicates that the results displayed in the MSRA secondary applica-
tion(s) no longer match the data captured by the MSRA primary. The "IQ" disappears
after the results in the secondary application(s) are refreshed.
Understanding the display information