Remote Commands
R&S
®
FSW
872
User Manual 1173.9411.02 ─ 43
Suffix:
<gap>
.
1 | 2
Gap (CACLR) channel number
Parameters:
<State>
ON | OFF | 1 | 0
*RST:
0
Example:
SENS:POW:ACH:FILT:GAP2 ON
Manual operation:
See
[SENSe:]POWer:ACHannel:GAP<gap>[:AUTO]:MSIZe
<Bandwidth>
If the gap between the sub blocks does not exceed the specified bandwidth, the gap
channels are not displayed in the diagram, and the gap channel results are not calcula-
ted in the result summary.
This command is only available for symmetrical gap channels in "Auto" gap mode (see
[SENSe:]POWer:ACHannel:GAP<gap>:MODE
Suffix:
<gap>
.
1 | 2
Gap channel number
Parameters:
<Bandwidth>
numeric value in Hz
*RST:
gap1: 5 MHz; gap2: 10 MHz
Default unit: Hz
Example:
POW:ACH:GAP2:MSIZ 5 MHz
Gap channel 2 is only evaluated if the gap is wider than 5 MHz.
Manual operation:
See
"Minimum gap size to show Gap 1/ Minimum gap size to
[SENSe:]POWer:ACHannel:SPACing:GAP<gap>[:AUTO]
<Spacing>
This command defines the distance from sub block to the specified gap channel.
In "Auto" gap mode, channels in the upper gap are identical to those in the lower gap.
Thus, only 2 gap channels are configured.
The spacing for gap channels is defined in relation to the outer edges of the surround-
ing sub blocks, i.e.
Spacing = [CF of the gap channel] - [left sub block center] + ([RF bandwidth of left sub
block] /2)
(See also
and
.)
Suffix:
<gap>
.
1 | 2
Gap channel number
Configuring and Performing Measurements
