R&S FSW Series, User Manual, Page: 177 / 1450

Measurements and Results
R&S
®
FSW
177 User Manual 1173.9411.02 ─ 43
[SENSe:]POWer:ACHannel:FILTer[:STATe]:ALTernate<ch>
on page 850
Alpha value:
[SENSe:]POWer:ACHannel:FILTer:ALPHa:CHANnel<ch>
on page 849
[SENSe:]POWer:ACHannel:FILTer:ALPHa:ACHannel
on page 848
[SENSe:]POWer:ACHannel:FILTer:ALPHa:ALTernate<ch>
on page 848
Channel Names
In the R&S FSW's display, carrier channels are labeled "Tx" by default; the first neigh-
boring channel is labeled "Adj" (adjacent) channel; all others are labeled "Alt" (alter-
nate) channels. You can define user-specific channel names for each channel which
are displayed in the result diagram and result table.
Remote command:
[SENSe:]POWer:ACHannel:NAME:ACHannel
on page 845
[SENSe:]POWer:ACHannel:NAME:ALTernate<ch>
on page 846
[SENSe:]POWer:ACHannel:NAME:CHANnel<ch>
on page 846
7.2.5 MSR ACLR Configuration
Access : "Overview" > "Select Measurement" > "Channel Power ACLR" > "CP / ACLR
Standard" > "Standard": "Multi-Standard Radio" > "CP / ACLR Config"
ACLR measurements can also be performed on input containing multiple signals for
different communication standards. A new measurement standard is provided that
allows you to define multiple discontiguous transmit channels at specified frequencies,
independent from the selected center frequency. If the "Multi-Standard Radio" standard
is selected (see
"Standard" on page 169), the "ACLR Setup" dialog box is replaced by
the "MSR ACLR Setup" dialog box.
For more information, see Chapter 7.2.3.4, "Measurement on Multi-Standard Radio
(MSR) Signals" , on page 162.
The remote commands required to perform these tasks are described in Chap-
ter 14.5.3, "Measuring the Channel Power and ACLR" , on page 841.
● General MSR ACLR Measurement Settings .........................................................177
● MSR Sub Block and Tx Channel Definition ...........................................................183
● MSR Adjacent Channel Setup .............................................................................. 185
● MSR Gap Channel Setup ......................................................................................188
● MSR Channel Names ........................................................................................... 193
7.2.5.1 General MSR ACLR Measurement Settings
Access : "Overview" > "Select Measurement" > "Channel Power ACLR" > "CP / ACLR
Standard" > "Standard": "Multi-Standard Radio" > "CP / ACLR Config" > "MSR General
Settings" tab
Channel Power and Adjacent-Channel Power (ACLR) Measurement