R&S FSW-K7, User Manual

Page: 68 / 407

Configuration
R&S
®
FSW-K7
68 User Manual 1173.9240.02 ─ 23
5.3.1.4 Analog Baseband Input Settings
Access : INPUT/OUTPUT > "Input Source Config" > "Analog Baseband" tab
The following settings and functions are available to provide input via the optional Ana-
log Baseband Interface in the applications that support it.
For more information on the optional Analog Baseband Interface, see the R&S FSW
I/Q Analyzer and I/Q Input User Manual.
Analog Baseband Input State ....................................................................................... 68
I/Q Mode ....................................................................................................................... 68
Input Configuration ........................................................................................................69
High Accuracy Timing Trigger - Baseband - RF ........................................................... 69
Center Frequency ......................................................................................................... 70
Analog Baseband Input State
Enables or disable the use of the "Analog Baseband" input source for measurements.
"Analog Baseband" is only available if the optional Analog Baseband Interface is instal-
led.
Remote command:
INPut:SELect
on page 191
I/Q Mode
Defines the format of the input signal.
For more information on I/Q data processing modes, see the R&S FSW I/Q Analyzer
and I/Q Input User Manual.
"I + jQ" The input signal is filtered and resampled to the sample rate of the
application.
Two inputs are required for a complex signal, one for the in-phase
component, and one for the quadrature component.
Input and Frontend Settings