R&S FSV-K7, Operating Manual, Page: 125 / 262

Analog Demodulation Option R&S FSV–K7
R&S
®
FSV-K7/K7S
125 Operating Manual 1176.7561.02 ─ 06
[SENSe:]ADEMod:AM[:ABSolute][:TDOMain]:RESult? <TraceMode>
This command reads the result data of the RF signal in zero span in the specified trace
mode. The data format of the output data block is defined by the FORMat command
(see
Chapter 2.3.6.2, "Formats for Returned Values: ASCII Format and Binary Format" ,
on page 118).
The output unit is dBm (logarithmic display) or V (linear display).
Query parameters:
<TraceMode> WRITe | AVERage | MAXHold | MINHold | VIEW
The specified trace mode must be one of those configured by
[SENSe:]ADEMod:AM[:ABSolute][:TDOMain][:TYPE]
on page 125. Otherwise a query error is generated.
For details on trace modes see
Chapter 2.3.6.1, "Trace Mode
Result Types" , on page 118.
Example: ADEM:SET 8MHz,32000,EXT,POS,-500,30
Sets up demodulator parameters
ADEM:AM AVER,MAXH,MINH
Sets up AM results to be measured
ADEM ON
Switches on demodulator
INIT; *WAI
Starts measurement and waits for sync
FORM ASC
Selects output format
ADEM:AM:RES? AVER
Reads AM average results
ADEM:AM:RES? MAXH
Reads AM max hold results
ADEM:AM:RES? MINH
Reads AM min hold results
Usage: Query only
Mode: ADEMOD
[SENSe:]ADEMod:AM[:ABSolute][:TDOMain][:TYPE] <TraceMode>
This command selects the trace modes of the RF signal to be measured simultane-
ously in zero span. For each of the six available traces a mode can be defined.
Parameters:
<TraceMode> <TraceMode1>, <TraceMode2>, <TraceMode3>, <Trace-
Mode4>, <TraceMode5>, <TraceMode6>
WRITe | AVERage | MAXHold | MINHold | VIEW | OFF
For details on trace modes see Chapter 2.3.6.1, "Trace Mode
Result Types" , on page 118.
*RST: WRITe,OFF,OFF,OFF,OFF,OFF (FM-
Stereo:OFF,OFF,OFF,OFF,OFF,OFF)
Remote Commands of the Analog Demodulation (R&S FSV–K7)