R&S FSV-K7, Operating Manual

Page: 111 / 262

Analog Demodulation Option R&S FSV–K7
R&S
®
FSV-K7/K7S
111 Operating Manual 1176.7561.02 ─ 06
Suffix:
<n>
.
window; For applications that do not have more than 1 measure-
ment window, the suffix <n> is irrelevant.
<t> trace
Parameters:
<Mode> WRITe | VIEW | AVERage | MAXHold | MINHold | BLANk
*RST:
WRITe for TRACe1, STATe OFF for
TRACe2/3/4/5/6
For details on trace modes refer to Chapter 2.1.7, "Trace Mode
Overview" , on page 17.
Example: INIT:CONT OFF
Switching to single sweep mode.
SWE:COUN 16
Sets the number of measurements to 16.
DISP:TRAC3:MODE MAXH
Switches on the calculation of the maximum peak for trace 3.
INIT;*WAI
Starts the measurement and waits for the end of the 16 sweeps.
Manual operation: See "Clear Write" on page 17
See "Max Hold" on page 18
See "Min Hold" on page 18
See "Average" on page 18
See "View" on page 18
DISPlay[:WINDow<n>]:TRACe<t>[:STATe] <State>
This command switches on or off the display of the corresponding trace. The other
measurements are not aborted but continue running in the background.
Suffix:
<n>
.
window; For applications that do not have more than 1 measure-
ment window, the suffix <n> is irrelevant.
<t> trace
Parameters:
<State> ON | OFF
*RST:
ON for TRACe1, OFF for TRACe2 to 6
Example: DISP:TRAC3 ON
Manual operation: See "Blank" on page 19
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe] <Range>
This command defines the display range of the y-axis with logarithmic scaling.
The command works only for a logarithmic scaling. You can select the scaling with
DISPlay[:WINDow<n>]:TRACe<t>:Y:SPACing
on page 114.
Remote Commands of the Analog Demodulation (R&S FSV–K7)