R&S FSPN, User Manual

Page: 346 / 555

Remote Control
R&S
®
FSPN
346 User Manual 1179.4363.02 ─ 01
Parameters:
<Voltage/Current> <numeric value>
The type of value depends on whether you control the output in
terms of current or voltage (
SOURce:VOLTage:POWer<i>:
LEVel:MODE
).
When you control it in terms of voltage, the value is a voltage
(V). When you control it in terms of current, the value is the cur-
rent (A).
Range:
0 to 16 V or 2000 mA
*RST: 16 V or 2000 mA
Default unit: V or A
Example: //Define a minimum current of 500 mA
SOUR:VOLT:POW:LEV:LIM:LOW 500MA
Manual operation: See "Defining the output level" on page 125
SOURce:VOLTage:POWer<i>:LEVel:MODE <Mode>
This command selects whether you want to control the output in terms of current or
voltage.
Suffix:
<i>
.
1..n
irrelevant
Parameters:
<Mode> CURRent
Control the output in terms of current.
VOLTage
Controls the output in terms of voltage.
*RST:
VOLTage
Example: //Control the V
supply
source in terms of voltages
SOUR:VOLT:POW:LEV:MODE VOLT
Manual operation: See "Selecting the output type (Vsupply only)" on page 125
SOURce:VOLTage:POWer<i>:LEVel[:STATe] <State>
This command turns the supply voltage source (V
supply
) on and off.
Note that DC power is actually supplied only if you additionally activate the outputs in
general.
Prerequisites for this command
●
Turn on DC power sources (
SOURce:VOLTage[:STATe]
).
Suffix:
<i>
.
1..n
irrelevant
Common Measurement Settings