R&S FSMR3000, User Manual

Page: 568 / 733

Remote Commands
R&S
®
FSMR3000
568 User Manual 1179.0116.02 ─ 02
Measurement settings include:
●
general channel configuration
●
measurement hardware configuration including markers
●
limit lines
Note that a configuration may include no more than 8 limit lines. This number
includes active limit lines as well as inactive limit lines that were used last.
Therefore the combination of inactivate limit lines depends on the sequence of use
with
MMEMory:LOAD:STATe
on page 571.
●
color settings
●
configuration for the hardcopy output
Parameters:
<State> ON | OFF | 0 | 1
*RST:
1
Example: MMEM:SEL:HWS ON
Manual operation: See "Items:" on page 247
MMEMory:SELect:CHANnel[:ITEM]:LINes:ALL <State>
MMEMory:SELect[:ITEM]:LINes:ALL <State>
This command includes or excludes all limit lines (active and inactive) when storing or
loading a configuration file.
Parameters:
<State> ON | OFF | 1 | 0
*RST:
0
Example: MMEM:SEL:LIN:ALL ON
Manual operation: See "Items:" on page 247
MMEMory:SELect:CHANnel[:ITEM]:NONE
MMEMory:SELect[:ITEM]:NONE
This command does not include any of the following items when storing or loading a
configuration file.
●
Hardware configuration:
MMEMory:SELect[:ITEM]:HWSettings
on page 567
●
Limit lines:
MMEMory:SELect[:ITEM]:LINes:ALL
on page 568
●
Spectrogram data:
MMEMory:SELect[:ITEM]:SGRam
on page 569
●
Trace data:
MMEMory:SELect[:ITEM]:TRACe<1...3>[:ACTive]
on page 569
●
Transducers:
MMEMory:SELect[:ITEM]:TRANsducer:ALL
on page 569
Example: MMEM:SEL:NONE
Manual operation: See "Items:" on page 247
Managing Settings and Results