R&S FSMR3000, User Manual

Page: 557 / 733

Remote Commands
R&S
®
FSMR3000
557 User Manual 1179.0116.02 ─ 02
The command works on all limit lines in all measurement windows at the same time.
Suffix:
<n>
.
Window
<li> irrelevant
Example: CALC:LIM:CLE
Deletes the result of the limit check.
CALCulate<n>:LIMit<li>:FAIL?
This command queries the result of a limit check in the specified window.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single measurement mode.
See also
INITiate<n>:CONTinuous
on page 473.
Suffix:
<n>
.
Window
<li> Limit line
Return values:
<Result> 0
PASS
1
FAIL
Example: INIT;*WAI
Starts a new sweep and waits for its end.
CALC2:LIM3:FAIL?
Queries the result of the check for limit line 3 in window 2.
Usage: Query only
12.6.6.4 Programming Example: Using Limit Lines
The following examples demonstrate how to work with limit lines in a remote environ-
ment.
● Example: Configuring Limit Lines ..........................................................................557
● Example: Performing a Limit Check ......................................................................559
Example: Configuring Limit Lines
This example demonstrates how to configure 2 limit lines - an upper and a lower limit -
for a measurement in a remote environment.
//------------- Configuing the limit lines ---------------------
CALC:LIM1:NAME 'FM1'
//Names limit line 1 'FM1'.
Analyzing Measurements (Basics)