R&S FSMR3000, User Manual

Page: 542 / 733

Remote Commands
R&S
®
FSMR3000
542 User Manual 1179.0116.02 ─ 02
ON | 1
Switches the function on
Example: DEM:SQU ON
Signals below the level threshold are not sent to the audio out-
put.
12.6.5 Configuring Display Lines
The commands required to configure display lines in a remote environment are descri-
bed here.
CALCulate<n>:DLINe<dl>
...............................................................................................542
CALCulate<n>:DLINe<dl>:STATe
.................................................................................... 542
CALCulate<n>:FLINe<dl>
............................................................................................... 543
CALCulate<n>:FLINe<dl>:STATe
.....................................................................................543
CALCulate<n>:TLINe<dl>
............................................................................................... 544
CALCulate<n>:TLINe<dl>:STATe
.....................................................................................544
CALCulate<n>:DLINe<dl> <Position>
This command defines the (horizontal) position of a display line.
Suffix:
<n>
.
Window
<dl> 1 | 2
Parameters:
<Position> The value range is variable.
You can use any unit you want, the R&S
FSMR3 then converts
the unit to the currently selected unit. If you omit a unit, the
R&S
FSMR3 uses the currently selected unit.
*RST: (state is OFF)
Default unit: DBM
Example: CALC:DLIN2 -20dBm
Positions the second display line at -20 dBm.
Manual operation: See "Horizontal Line 1/ Horizontal Line 2" on page 180
CALCulate<n>:DLINe<dl>:STATe <State>
This command turns a display line on and off
Suffix:
<n>
.
Window
<dl> 1 | 2
Parameters:
<State> ON | OFF | 0 | 1
Analyzing Measurements (Basics)