R&S FSMR3000, User Manual

Page: 475 / 733

Remote Commands
R&S
®
FSMR3000
475 User Manual 1179.0116.02 ─ 02
DISPlay[:WINDow<n>]:SIZE <Size>
This command maximizes the size of the selected result display window temporarily .
To change the size of several windows on the screen permanently, use the
LAY:SPL
command (see
LAYout:SPLitter
on page 478).
Suffix:
<n>
.
Window
Parameters:
<Size> LARGe
Maximizes the selected window to full screen.
Other windows are still active in the background.
SMALl
Reduces the size of the selected window to its original size.
If more than one measurement window was displayed originally,
these are visible again.
*RST:
SMALl
Example: DISP:WIND2:SIZE LARG
12.5.11.2 Working with Windows in the Display
The following commands are required to change the evaluation type and rearrange the
screen layout for a channel as you do using the SmartGrid in manual operation. Since
the available evaluation types depend on the selected application, some parameters
for the following commands also depend on the selected channel.
Note that the suffix <n> always refers to the window in the currently selected channel .
LAYout:ADD[:WINDow]?
................................................................................................. 475
LAYout:CATalog[:WINDow]?
............................................................................................ 476
LAYout:IDENtify[:WINDow]?
............................................................................................ 477
LAYout:MOVE[:WINDow]
................................................................................................ 477
LAYout:REMove[:WINDow]
............................................................................................. 478
LAYout:REPLace[:WINDow]
............................................................................................ 478
LAYout:SPLitter
..............................................................................................................478
LAYout:WINDow<n>:ADD?
............................................................................................. 480
LAYout:WINDow<n>:IDENtify?
........................................................................................ 480
LAYout:WINDow<n>:REMove
..........................................................................................481
LAYout:WINDow<n>:REPLace
........................................................................................ 481
LAYout:WINDow<n>:TYPE
..............................................................................................482
LAYout:ADD[:WINDow]? <WindowName>,<Direction>,<WindowType>
This command adds a window to the display in the active channel.
This command is always used as a query so that you immediately obtain the name of
the new window as a result.
To replace an existing window, use the
LAYout:REPLace[:WINDow]
command.
Configuring the Measurement