R&S FSMR3000, User Manual

Page: 426 / 733

Remote Commands
R&S
®
FSMR3000
426 User Manual 1179.0116.02 ─ 02
DIAGnostic:SERVice:NSOurce <State>
This command turns the 28 V supply of the BNC connector labeled [noise source
control] on the R&S
FSMR3000 on and off.
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Example: DIAG:SERV:NSO ON
Manual operation: See "Noise Source Control" on page 152
SYSTem:SPEaker:VOLume <Volume>
This command defines the volume of the built-in loudspeaker for demodulated signals.
This setting is maintained for all applications.
The command is available in the time domain in Spectrum mode and in Analog Modu-
lation Analysis mode.
Parameters:
<Volume> Percentage of the maximum possible volume.
Range:
0 to 1
*RST: 0.5
Example: SYST:SPE:VOL 0
Switches the loudspeaker to mute.
OUTPut<up>:IF[:SOURce] <Source>
Defines the type of signal available at one of the output connectors of the
R&S
FSMR3000.
Suffix:
<up>
.
Parameters:
<Source> IF
The measured IF value is available at the IF/VIDEO/DEMOD
output connector.
*RST:
IF
Example: OUTP:IF VID
Selects the video signal for the IF/VIDEO/DEMOD output con-
nector.
Manual operation: See "IF/Video Output" on page 151
Configuring the Measurement