R&S FSMR3000, User Manual

Page: 173 / 733

Common Analysis and Display Functions
R&S
®
FSMR3000
173 User Manual 1179.0116.02 ─ 02
8 Common Analysis and Display Functions
Access : "Overview" > "Analysis"
General methods and basic settings to display and analyze measurements, regardless
of the operating mode, are described here. If you are performing a specific measure-
ment task, using an operating mode other than Signal and Spectrum Analyzer mode,
or an application other than the Spectrum application, be sure to check the specific
application or mode description for settings and functions that may deviate from these
common settings.
● Result Display Configuration .................................................................................173
● Zoomed Displays .................................................................................................. 194
● Marker Usage ........................................................................................................200
● Trace Configuration ...............................................................................................214
● Importing and Exporting Measurement Results for Evaluation .............................232
8.1 Result Display Configuration
Measurement results can be evaluated in many different ways, for example graphically,
as summary tables, statistical evaluations etc. Thus, the result display is highly config-
urable to suit your specific requirements and optimize analysis. Here you can find out
how to optimize the display for your measurement results.
Basic operations concerning the R&S FSMR3 display, for example how to use the
SmartGrid, are described in Chapter 4.5.5.2, "Laying out the Result Display with the
SmartGrid" , on page 76.
General display settings that are usually configured during initial instrument setup,
independently of the current measurement, e.g. which items or colors are displayed on
the screen, are described in
Chapter 10.2, "Display Settings" , on page 275.
● Basic Evaluation Methods .....................................................................................173
● Laying out the Result Display with the SmartGrid .................................................175
● Display and Limit Lines ......................................................................................... 179
8.1.1 Basic Evaluation Methods
Measurement results can be displayed and evaluated using various different methods,
also at the same time. Depending on the currently selected measurement, in particular
when using optional firmware applications, not all evaluation methods are available.
The evaluation methods described here are available for most measurements in the
Measuring Receiver application.
Diagram .......................................................................................................................174
Marker Table ............................................................................................................... 174
Marker Peak List ......................................................................................................... 174
Result Summary ..........................................................................................................175
Result Display Configuration