R&S FSMR3000, User Manual, Page: 150 / 733

Common Measurement Settings
R&S
®
FSMR3000
150 User Manual 1179.0116.02 ─ 02
7.4.2 Sweep Settings
Access : "Overview" > "Data Acquisition" > "Sweep" tab
The sweep settings define how often data from the input signal is acquired and then
demodulated.
Measurement Time (AQT) ...........................................................................................150
Sweep Points .............................................................................................................. 150
Sweep/Average Count ................................................................................................ 150
Measurement Time (AQT)
Defines how long data is acquired for demodulation.
Remote command:
[SENSe:]ADEMod:MTIMe
on page 437
Sweep Points
Defines the number of measured values to be collected during one sweep.
Remote command:
[SENSe:]SWEep[:WINDow<n>]:POINts
on page 440
Sweep/Average Count
Defines the number of measurements to be performed in the single sweep mode. Val-
ues from 0 to 200000 are allowed. If the values 0 or 1 are set, one measurement is
performed.
Remote command:
[SENSe:]SWEep:COUNt
on page 439
7.5 Output
7.5.1 Output Settings
The R&S FSMR3 can provide output to special connectors for other devices.
Output