Remote Control
R&S
®
ESR
907
User Manual 1175.7068.02 ─ 12
Usage:
SCPI confirmed
Manual operation:
See
SOURce<n>:POWer:STOP
<Power>
This command defines the stop power of the power sweep. The stop value can be
smaller than the start value.
Suffix:
<n>
.
1...4
Selects the measurement window.
Parameters:
<Power>
Range:
-30 dBm to +5 dBm
*RST:
0 dBm
Example:
SOUR:POW:STOP -20dBm
Usage:
SCPI confirmed
Manual operation:
See
11.7.2
Controlling the External Tracking Generator
[SENSe:]CORRection:TRANsducer:GENerator
.................................................................907
SOURce<n>:EXTernal<generator>:FREQuency
................................................................908
SOURce<n>:EXTernal<generator>:FREQuency:COUPling[:STATe]
.................................... 908
SOURce<n>:EXTernal<generator>:FREQuency[:FACTor]:DENominator
..............................909
SOURce<n>:EXTernal<generator>:FREQuency[:FACTor]:NUMerator
................................. 909
SOURce<n>:EXTernal<generator>:FREQuency:OFFSet<m>
.............................................910
SOURce<n>:EXTernal<generator>:FREQuency:SWEep[:STATe]
........................................ 911
SOURce<n>:EXTernal<generator>:POWer[:LEVel]
............................................................911
SOURce<n>:EXTernal<generator>:ROSCillator[:SOURce]
................................................. 911
SOURce<n>:EXTernal<generator>[:STATe]
...................................................................... 912
SYSTem:COMMunicate:GPIB:RDEVice:GENerator<generator>:ADDRess
.......................... 913
SYSTem:COMMunicate:RDEVice:GENerator<generator>:INTerface
................................... 913
SYSTem:COMMunicate:RDEVice:GENerator<generator>:LINK
.......................................... 913
SYSTem:COMMunicate:RDEVice:GENerator<generator>:TYPE
.........................................914
[SENSe:]CORRection:TRANsducer:GENerator
<Name>
This command uses the normalized measurement data to generate a transducer factor
with up to 625 points. The trace data is converted to a transducer with unit dB and
stored in a file with the specified name and the suffix.trd under
c:\r_s\instr\trd
.
The frequency points are allocated in equidistant steps between start and stop fre-
quency. The generated transducer factor can be further adapted using the commands
of the
[SENSe<source>:]CORRection:TRANSducer
This command is only available if the R&S
FSV-B10 option (External Tracking Genera-
tor) is installed and normalization is switched on.
Remote Commands to Control the Tracking Generator
