Remote Control
R&S
®
ESR
718
User Manual 1175.7068.02 ─ 12
Suffix:
<n>
.
irrelevant
<k>
irrelevant
Example:
CALC:LIM:CLE
Deletes the result of the limit check.
Usage:
Event
CALCulate<n>:LIMit<k>:FAIL?
This command queries the result of a limit check.
Note that for SEM measurements, the limit line suffix <k> is irrelevant, as only one spe-
cific SEM limit line is checked for the currently relevant power class.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweeps.
Suffix:
<n>
.
irrelevant
<k>
limit line
Return values:
<Result>
0
PASS
1
FAIL
Example:
INIT;*WAI
Starts a new sweep and waits for its end.
CALC:LIM3:FAIL?
Queries the result of the check for limit line 3.
Usage:
Query only
Manual operation:
See
See
CALCulate<n>:LIMit<k>:STATe
<State>
This command turns the limit check on and off.
To query the limit check result, use
.
Suffix:
<n>
.
irrelevant
<k>
Selects the limit line.
Parameters:
<State>
ON | OFF
*RST:
OFF
Remote Commands in Receiver Mode
