Interfaces and Connectors
R&S
®
DVMS1
19
Getting Started 2113.7619.02 ─ 12
●
LED green: Input is used for monitoring. Synchronization state is valid for both RF
signal and related transport stream.
●
LED yellow: Input is used for monitoring but synchronization cannot be achieved.
TS IN
This BNC socket is used to feed in an MPEG2 transport stream signal conforming to
the DVB
‑
ASI (EN 50083
‑
9 (2002)) or SMPTE (SMPTE 310M) interface standards.
An LED indicates the TS IN status:
●
LED off: Input is not used for monitoring.
●
LED green: Input is used for monitoring. Synchronization state is valid for the trans-
port stream signal.
●
LED yellow: Input is used for monitoring but synchronization cannot be achieved.
TS OUT
This BNC socket provides an MPEG2 transport stream signal conforming to the
DVB
‑
ASI (EN 50083
‑
9 (2002)) interface standard.
The interface is used as a loop output for a transport stream signal from the [RF In] or
[TS In] input (see above).
An LED indicates the TS OUT status:
●
LED off: Output is not used.
●
LED blue: Output is used as loop output.
3.2.8
DVB-T/DVB-T2 Receiver Module (R&S
DVMS-B55)
The T/T2 receiver module (R&S
DVMS
‑
B55) is an option module.
Figure 3-4: DVB-T/T2 receiver module
The status of the connectors is indicated by LEDs. Before showing a new state, each
LED holds the current state for at least one second, if the current state is not "off" or
"flashing".
To select the input, in the toolbar, click "Instrument Configuration" and then select "Sig-
nal Interface". See the user manual or help system.
To help locating a connector socket, you can let its status LED flash blue ("Instrument
Configuration" dialog, "Signal Interfaces" tab, see the user manual or help system).
Rear Panel
