CDMA2000 Signaling
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
583
User Manual 1173.9511.02 ─ 11
Pie Charts
Illustrate the percental proportion of the forward and reverse speech frames since the
beginning of the measurement. The various colors are assigned to the particular frame
rate sets as displayed on the left side of the speech activity table.
Reset Statistics
Softkey "Reset Statistics" sets all counters to zero, relevant for RLP and speech views
only.
Remote command:
4.4 Programming
The following sections provide programming examples for the CDMA2000 signaling.
The examples have been tested with the aid of a simple software tool.
The examples contain SCPI commands supported by the R&S
CMW and the following
symbolic scripting commands:
●
// <comment>
:
Adds a <comment> to the protocol generated during execution of the example.
●
WHILE <query> <> <value>
:
Waits until the <query> returns a certain <value>, e.g. a specific state is reached.
●
WAITKEY <message>
:
Displays a dialog box with a <message> and wait until the box is closed by the
user.
See also: "Remote Control" in the R&S
CMW user manual
...........................................................................................583
.................................................................................593
.............................................................................594
....................................................................................596
4.4.1 General Configuration
The CDMA2000 signaling is programmed as follows:
●
The application is controlled by SCPI commands with the following syn-
tax:
...CDMA:SIGN:...
●
After a
*RST
, the FL signal is switched off.
–
To activate the FL signal use
SOURce:CDMA:SIGN:STATe ON
.
Query the cell state using
SOURce:CDMA:SIGN:STATe:ALL?
. The result
ON,ADJ
indicates that the FL signal is available.
Programming
深圳德标仪器
135-1095-0799
