1xEV-DO Measurements
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
369
User Manual 1173.9511.02 ─ 11
For a physical layer subtype 2 or 3 measurement, the bar graphs contain only RRI
results. For a physical layer subtype 0/1 measurement the bar graphs contain also pilot
results, see
.
Return values:
<Reliability>
<SigRRILimit0> ...
<SigRRILimitSF>
The number of results depends on the physical layer subtype
(see
): SF=15 for Subtype 0/1 and SF=31 for Subtypes 2 and 3.
OK
: The result is located within the limits or no limit has been
defined/enabled for this result.
ULEU
(User limit exceeded upper): An upper limit is violated.
The result is located above the limit.
ULEL
(User limit exceeded lower): A lower limit is violated. The
result is located below the limit.
Range:
OK | ULEU | ULEL
Usage:
Query only
Firmware/Software:
V2.0.10
FETCh:EVDO:MEAS<i>:MEValuation:TRACe:CDE:ISIGnal:RRI:STATe?
FETCh:EVDO:MEAS<i>:MEValuation:TRACe:CDE:QSIGnal:RRI:STATe?
Return the states of the code domain error (CDE) I-Signal and Q-Signal bar graphs.
For a physical layer subtype 2 or measurement the bar graphs contain only RRI
results. For a physical layer subtype 0/1 measurement the bar graphs contain also pilot
results, see
.
Return values:
<Reliability>
<SigRRIState0> ...
<SigRRIStateSF>
NAV | ACTive | INACtive
The number of results depends on the physical layer subtype
(see
): SF=15 for Subtype 0/1 and SF=31 for Subtypes 2 and 3 (only
NAV values).
NAV
: No channel available
ACTive
: Active code channel
INACtive
: Inactive code channel
Usage:
Query only
Firmware/Software:
V2.0.10
FETCh:EVDO:MEAS<i>:MEValuation:TRACe:CDE:ISIGnal:PILot:CURRent?
FETCh:EVDO:MEAS<i>:MEValuation:TRACe:CDE:ISIGnal:PILot:AVERage?
FETCh:EVDO:MEAS<i>:MEValuation:TRACe:CDE:ISIGnal:PILot:MAXimum?
Command Reference
深圳德标仪器
135-1095-0799
