R&S AREG800A, User Manual

Page: 86 / 411

Configuring the measurement setup
R&S
®
AREG800A
86 User Manual 1179.3615.02 ─ 01
Add Sensor
Adds a configuration for a connected sensor.
A line with contiguous numeration is added below the already listed sensors. "Alias >
Sensor" is assigned automatically. Also, a new side tab labelled "Sensor" "ID = Sx"
appears to the right of the dialog. "x" represents the number of the added sensor.
Remote command:
[:SOURce<hw>]:AREGenerator:SENSor<ch>:ADD
on page 334
6.3.2 Sensor settings
Access:
► Select "Sensor Config > Sensor".
The "Sensor" "ID = Sx" side-tab provides settings related to the connected sensor,
that is represented by its "ID". "x" can range from 1 to 8.
Each fo the "Sensor" side-tabs provide the following settings, that are individual for
each connected sensor:
●
Center frequency and frequency bandwidth of the output RF signal
●
Relative distance and relative angle of the sensor relative to the signal source
Settings:
Center Frequency ......................................................................................................... 86
Bandwidth ..................................................................................................................... 86
Sensor to Origin ............................................................................................................ 87
└ Relative Distance ............................................................................................ 87
└ Relative Angle .................................................................................................87
Center Frequency
Sets the center frequency expected at the connected sensor.
Remote command:
[:SOURce<hw>]:AREGenerator:SENSor<ch>:CENTer
on page 335
Bandwidth
Sets the bandwidth of the frequency signal expected at the connected sensor.
Sensor configuration