R&S AREG800A, User Manual

Page: 87 / 411

Configuring the measurement setup
R&S
®
AREG800A
87 User Manual 1179.3615.02 ─ 01
Remote command:
[:SOURce<hw>]:AREGenerator:SENSor<ch>:BW
on page 335
Sensor to Origin
Configures relative distance and relative angle of sensor to origin.
Relative Distance ← Sensor to Origin
Sets the relative distance between sensor and origin.
Remote command:
[:SOURce<hw>]:AREGenerator:SENSor<ch>:DISTance
on page 335
Relative Angle ← Sensor to Origin
Sets the relative angle between sensor and origin.
Remote command:
[:SOURce<hw>]:AREGenerator:SENSor<ch>:ANGLe
on page 335
6.4 Channel configuration
Access:
► Select "Measurement Setup > Configuration > Channel Config".
The "Channel Config" tab of the "Measurement Setup" dialog opens.
Settings:
● Overview ................................................................................................................. 87
● Channel settings ..................................................................................................... 88
6.4.1 Overview
Access:
► Select "Measurement Setup > Configuration > Channel Config > Overview".
The "Overview" side-tab provides a list of eight channels of the R&S AREG800A.
You can configure the state and alias for eight channels individually.
Settings:
ID ...................................................................................................................................87
State ..............................................................................................................................88
Alias/Channel ................................................................................................................ 88
Channel Bandwidth ....................................................................................................... 88
ID
Displays the identification name of the radar channel.
Channel configuration