R&S AREG800A, Getting Started

Page: 37 / 64

Instrument tour
R&S
®
AREG800A
37 Getting Started 1179.3609.02 ─ 02
SD card slot
SD card slot.
USB
Female USB (universal serial bus) 2.0 connector of type A, to connect devices
like external USB devices, a mouse or a keyboard for enhanced operation.
You can also connect R&S NRP power sensors (with an R&S NRP-Z4 or an R&S
NRP-ZKU adapter cable) for external power measurements. Also, you can con-
nect a memory stick for software updates and data exchange.
Further USB connectors of type A are available on the rear panel.
How to:
Chapter 4.8, "Connecting USB devices" , on page 21
Sensor
Connector for R&S NRP sensors.
The connector is a six-pole ODU Mini-Snap
® series B connector.
A power sensor is connected to the R&S AREG800A by inserting the male con-
nector. To disconnect, pull the connector by its sleeve. You cannot disconnect the
sensor simply by pulling at the cable or the rear part of the connector.
The R&S
AREG800A supports the use of R&S NRP power sensors in various
ways including the use as a power viewer.
How to: Chapter "Using Power Sensors" in the user manual
5.2 Rear panel tour
This section provides an overview of the connectors on the rear panel of the
instrument. For technical data of the connectors, refer to the data sheet.
Rear panel tour