R&S AREG800A, Getting Started

Page: 21 / 64

Preparing for use
R&S
®
AREG800A
21 Getting Started 1179.3609.02 ─ 02
To connect to LAN
The connector is located on the rear panel .
► Connect the LAN socket via an RJ-45 cable to the LAN.
By default, the R&S AREG800A is configured to use DHCP (dynamic host config-
uration protocol) and no static IP address is configured.
If switched on and connected to the LAN, the R&S AREG800A displays the
address information on the screen.
Figure 4-1: IP address indication on the screen (example)
See also the chapter "Connecting the Instrument to the Network (LAN)" in the
user manual.
4.8 Connecting USB devices
You can connect or disconnect all USB devices from the R&S AREG800A during
operation.
To connect USB storage devices
USB storage devices, such as memory sticks, allow data transfer from or to the
R&S
AREG800A. You can also use them for firmware updates.
► Connect the USB storage device to any of the USB connectors.
To connect USB devices with external power supply
1. NOTICE! Connected devices with external power supply can feed back cur-
rent into the 5 V power supply of the USB interface and thus damage the
R&S AREG800A.
Ensure that there is no connection between the positive pole of the power
supply and the +5
V power pin of the USB interface (VBUS).
Connecting USB devices