R&S 4900.8005.K20, User Manual

Page: 96 / 157

Troubleshooting
R&S
®
TSMA6B
96 User Manual 4901.4026.02 ─ 01
9 Troubleshooting
For all troubleshooting procedures, connect keyboard, mouse and a monitor to the
R&S TSMA6B.
● LED indicated errors ............................................................................................... 96
● Evaluate selftest file ................................................................................................ 97
● Verify scanner link / recall device info using TsmeDeviceManager .........................97
● R&S TSMA6B automatically switches off after power on ......................................101
● Scanner is not found from software (R&S ROMES, R&S NESTOR) .................... 102
● Verify scanner connection LAN settings ................................................................105
● No RF / GPS data ................................................................................................. 106
● No remote access via LAN port ............................................................................ 108
● WLAN access point not detected by external PC, mobile or tablet ....................... 111
● Web GUI not accessible via WLAN .......................................................................114
● Web GUI locally not accessible .............................................................................115
● Slow/Instable WLAN connection ........................................................................... 117
●
Bluetooth
®
device not detected by R&S TSMA6B .................................................119
● Contacting Customer Support ...............................................................................121
9.1 LED indicated errors
●
"Mode" LED blue blinking fast
−
Selftest Error
– Check the scanner connection (see Chapter 9.6, "Verify scanner connection
LAN settings" , on page 105).
– Evaluate the
Selftestresult.txt
(see Chapter 9.2, "Evaluate selftest file" ,
on page 97).
●
"State" LED red blinking (2 Hz)
−
Temperature Warning
– Check the ventilation openings and the operating temperature.
– Switch off the device and let it cool down.
●
"State" LED red continuous
−
Overheated Unit
– Switch off the device and let it cool down.
– Check the ventilation openings and switch on the device. If the problem occurs
again, analyze the
Selftestresult.txt
(see Chapter 9.2, "Evaluate self-
test file" , on page 97).
●
"Meas" LED red blinking (2 Hz)
−
Application Error
– Refer to the application note of the used software.
●
"Pwr" LED off after startup
−
Power Error
– Contact R&S support.
LED indicated errors