R&S 1332.4500K22, User Manual

Page: 561 / 1709

GUI reference
R&S
®
ZNA
561 User Manual 1178.6462.02 ─ 20
Remote command:
[SENSe<Ch>:]CORRection:CONNection
[SENSe<Ch>:]CORRection:CONNection:CATalog?
[SENSe<Ch>:]CORRection:CONNection:DELete
5.11.2.2 Calibration Kits dialog
The "Calibration Kits" dialog shows the available calibration kits for the different con-
nector types. It is also used for cal kit and cal kit file management.
Access: Channel – [Cal] > "Cal Devices" > "Cal Kits..."
Related information
Refer to the following sections:
●
See also Chapter 4.5.2, "Calibration standards and calibration kits" , on page 172
●
Chapter 4.5.2.4, "Cal kit Files" , on page 177
●
Chapter 4.5.2.2, "Cal kit parameter types" , on page 175
●
Chapter 5.11.2.1, "Cal Connector Types dialog" , on page 558
The contents of the "Available Cal Kits" table vary, depending on the selected "Connec-
tor Type". The table can also contain kits with ideal or typical parameter values; see
Cal kit parameter types . The "Keysight Model" is an optional scheme to characterize
the offset parameters of the standards; see "Offset Parameters" on page 566.
Cal kit labels
Assigning a "Label" to user-defined calibration kits is optional. However, the label is
displayed in many dialogs and can provide useful information about the kit, e.g. its
serial number. It is even possible to assign several calibration kits with the same name,
distinguished by their label, to a common connector type. See also
Chapter 7.3.14.8,
"[SENSe:]CORRection:CKIT... with Labels" , on page 1254.
Cal softtool