R&S 1129.7246.03, Operating Manual

Page: 75 / 855

R&S ESU Instrument Functions
Receiver Mode
4.44 Operating Manual 1302.6163.12 - 03
RUN
FINAL MEAS
Sequence for RUN FINAL MEAS
The RUN FINAL MEAS softkey starts the final measurement sequence as described
below. The HOLD FINAL MEAS submenu is called.
Dependent on the selected measurement mode ( AUTOMATIC FINAL or INTER
ACTIVE ) for the final measurement, two different submenus of the HOLD FINAL
MEAS menu are displayed.
The detectors used for the final measurement replace those used in the list or for the
prescan.
The out-of-limit condition is shown by a plus sign preceding the values in the DELTA
LIMIT column (see table below).
Remote command:
--
HOLD
FINAL MEAS
Dependent on the selected measurement mode ( AUTOMATIC FINAL or INTER
ACTIVE ) for the measurement, two different submenus of the HOLD FINAL MEAS
menu are displayed.
The HOLD FINAL MEAS softkey interrupts the automatic run of the final measure-
ment.
The CONTINUE FINAL MEAS submenu appears.
Sequence for AUTOMATIC FINAL
With the final measurement halted all receiver settings can be modified for example
for examining the signal in detail.
The mode of the measurement (automatic or interactive) can again be selected.
The final measurement can be started with the MEASURE softkey.
Remote command:
--
AUTOMATIC
FINAL
The AUTOMATIC FINAL softkey selects the automatic mode for the final measure-
ment (see above).
Remote command:
:FME:AUTO ON
The final measurement function is only available in the manual operation. For
operation under program control it is preferable to read the prescan results and
the data-reduced peak list, if any, from the R&S ESU with the controller and carry
out the individual measurements with the controller. This considerably makes the
control of the interactive mode easier.
HOLD FINAL MEAS
!
AUTOMATIC FINAL
INTER ACTIVE
MEASURE
STOP FINAL MEAS
STOP FINAL MEAS