ANTIMASK ENABLE
The enabling of the Antimask function is the last operation to be
made. Set the Dip Switch N°1 in ON position, the red led will
flash for 60 seconds In this 60 seconds close the front cover
and move away quickly from the detector. The detector will get
in the autoset modality. In this phase the leds will light
alternately, and the detector will make the automatic calibration
of the antimask level in function of the ambient. It’s important
that during this phase that nothing should be present near the
detector to not compromise the autosetting.
Is recommended to disable the ANTIMASK function all
the times that an operation is made on the detector.
LED OFF:
DIP SWITCH N°5
The ON position disables the display of detection and alarm.
With the INHIBIT line connected, when the system will be
armed off, the detector will enable the display for 30 sec. from
the first detection.
RELAYS INHIBITION
With the INHIBIT line connected, at the arming off of the
system, the alarm relays will be inhibited.
MEMORIES
With the INHIBIT line connected, at the arming off of the
system, the memory will be activated. It will display the eventual
memory of the cause that has generated the first alarm, by the
lighting of the LED’s. (see Tab.1), which will be reset by the
control panel unit at its insertion.
If no alarm has been memorised, the LED’s will continue to
display the detection.
SPECIFICATION
VOLTAGE:
12V +/- 30 %
CURRENT MAX:
40mA
CURRENT stand by:
20mA
MICROWAVE:
microstrip 8dBm
9.5 - 10.6 Ghz
ALARM PERIOD:
3 sec
RFI IMMUNITY:
0.1 to 500 Mhz
3 V/m
SOLID STATE RELAY:
100mA / 24V
COVER TAMPER :
100mA / 30V
WALL TAMPER:
300mA / 48V
OPERATING TEMP:
-10°C/+55°C
CERTIFICATED TEMP.: +5°C/+40°C
AMBIENT UMIDITY: 95%
MTBF TEORIC:
98.803 ORE
DIMENSIONS:
108 x 64 x 46 mm
PERFORMANCE LEVEL:
IMQ I°Liv.
(With kit Wall tamper):
IMQ II°Liv.
R&D Electronics
s.r.l.
Stab. Via D. Beccafumi, 61/65 - 00133 Roma
Tel. +39 06 2008368 - Fax +39 06 20686322
www.rdelectronics.it e-mail [email protected]
MADE IN ITALY
4
