5
No hot or cold
water
ELIMINATION
No water running
out from taps
Leakage from
bottle supporter
Noisy operation Not placid installation.
Broken bottle.
1. Empty bottle.
2. Inlet of bottle supporter.
blocked by bottle seal.
1. Over consumption of hot
or cold water in short time.
2. No power supply.
1. Just wait a moment, then hot or
cold water is available again.
2. Connect plug to socket, turn on
heating or cooling switch.
1. Replace it with another one.
2. Clean out wasted paper&bottle
seal, install bottle again.
Replace it with a new bottle.
Place the machine on
placid & solid surface.
POSSIBLE CAUSES
PROBLEMS
F. TROUBLE SHOOTING
G. CLEANING
Please check the followings before having the machine repaired.
To avoid accident, cut off the power supply before operation
according to the following instructions.
1.
The machine had been disinfected before departed from factory.
Cleaning the dispenser prior to installing a full bottle or water for the
first time.
2. Cleaning and draining instruction:
Before cleaning, make sure the power switch in the O(off) position and
unplug the water dispenser.
Vertically insert the bottle into the supporter on tap of the machine.
Open the taps, let about 1 liter water flow into a container.
Remove the water bottle from the dispenser.
Place a large bucket beneath the drain outlet. Remove the drain cover
and allow water to drain.
After draining, replace the drain cover and you can use the machine.
Attention:
The dispenser heats water to a temperature of approximately
185 F/85 C. It can cause sever scalding. Please operate it carefully.
