PART FIGURE
Base
Note: All the pictures in this manual are for explanation purpose only.
Any discrepancy between the real object and the illustration in the
drawing shall be subject to the real subject.
‘7’finger screw
Front guard
Circlip Spinner
Plastic nut
Rear guard
Clutch knob
Motor
housing
Tighten
knob
Internal Pole
Extension
Pole
Height
adjustment
ring
Piano
switch
Motor
shaft
Fan blade
1. Unscrew the “7” finger screw
from the Extension Pole. (Fig.1)
2. Insert the extension pole in the base and tighten the “7” Finger screw. (Fig.2)
3. From the extension pole loosen the height adjustment ring and adjust the internal
pipe to the desired height. (Note: If you can’t find the internal pole, it slides inside
the extension pole. You can pull it out from the extension pole.) (Fig.3)
4. To attach the head unit to the extension pole, loosen the thumb screw on the
bottom of the head unit. Place the head unit on the extension pole and tighten the
thumb screw in alignment with the groove on the internal pole. (Fig.4)
CAUTION:
Height adjustment ring must be fully fastened before the assembly of the
motor section to the extension pole.
ASSEMBLY OF BASE & COLUMN UNIT
2