1 OM-914207-0211-D
RAMSEY HYDRAULIC PLANETARY WINCH MODEL WILDCAT 80K
PLEASE READ THIS MANUAL CAREFULLY
This manual contains useful ideas in obtaining the most efficient operation from your Ramsey Winch, and safety
procedures one needs to know before operating a Ramsey Winch. Do not operate this winch until you have carefully
read and understand the "WARNINGS" and "OPERATION" sections of this manual.
WARRANTY INFORMATION
Ramsey Winches are designed and built to exacting specifications. Great care and skill go into every winch we make.
If the need should arise, warranty procedure is outlined on the back of your self-addressed postage paid warranty card.
Please read and fill out the enclosed warranty card and send it to Ramsey Winch Company. If you have any problems
with your winch, please follow instructions for prompt service on all warranty claims. Refer to back page for limited
warranty.
SPECIFICATIONS*
APPROXIMATE WEIGHT:
1700 LBS
WORKING PRESSURE:
2500 PSI
CABLE DIAMETER:
1 INCH
MAX FLOW:
60 GPM
LAYER
OF
CABLE
CABLE
CAPACITY
LOW SPEED
HIGH SPEED
LINE PULL
LINE SPEED
LINE PULL
LINE SPEED
Ft m Lb
Kg
fpm
mpm
Lb
Kg fpm
mpm
1 50
20
80000
36280
30
9
30000
13630 60 18
2 115
45
66600 30200
36
11
25000
11350 72 22
3 185
73
57100 25900
42
13
21400
9730 84 26
4 270
106
50000 22670
48
15
18700
8520 96 29
5 365
144
44400 20130
54
16
16600
7560 108 33
* These specifications are based on recommended wire rope of 1” Extra Improved Plow Steel Cable and a 9.0
cu. in. / Rev. motor.
NOTE:
The rated line pulls shown are for the winch only. Consult the wire rope manufacturer for wire rope ratings.
WARNINGS:
CLUTCH MUST BE FULLY ENGAGED BEFORE STARTING THE WINCHING OPERATION.
DO NOT START WINCH MOTOR BEFORE ENGAGING CLUTCH.
DO NOT DISENGAGE CLUTCH UNDER LOAD.
STAY OUT FROM UNDER AND AWAY FROM RAISED LOADS.
STAND CLEAR OF CABLE WHILE PULLING. DO NOT TRY TO GUIDE CABLE.
DO NOT EXCEED MAXIMUM LINE PULL RATINGS SHOWN IN TABLE.
DO NOT USE WINCH TO LIFT, SUPPORT, OR OTHERWISE TRANSPORT PEOPLE.
A MINIMUM OF 5 WRAPS OF CABLE AROUND THE DRUM BARREL IS NECESSARY TO HOLD THE LOAD.
CABLE ANCHOR IS NOT DESIGNED TO HOLD LOAD.
BAND BRAKE IS NOT TO BE USED TO HOLD LOAD
