![background image](http://html1.mh-extra.com/html/ramsey-electronics/uam2/uam2_quick-manual_3591774007.webp)
UAM2
•
7
be installed by holding it with tweezers in contact with the “tinned” trace and
re-heating the solder (see the associated diagrams). Another commonly used
technique is to glue the surface mount components to the printed circuit board
before soldering. The procedure is to take a small amount of glue (usually with
a pin or toothpick) and “dab” the circuit board in the place where the
component will be affixed. Be careful not to apply too much glue as when the
part is placed it may “squash” the glue underneath the soldering tabs of the
component. Carefully place the part into position, and when the glue dries,
solder the connection.