UAM2
•
10
18. Install L1, surface mount ferrite bead, under D3.
19. Install C2, 1 uF surface mount capacitor, under L1.
20. Install C13, .22 uF surface mount capacitor, to the left of C2.
21. Install R1, 51 ohm surface mount resistor, to the left of C13.
22. Install C3, 1 uF surface mount capacitor, to the left of R1.
23. Install R6, 120K ohm surface mount resistor, down and to the left of
C3.
24. Install C1, that big ol’ beast electrolytic surface mount capacitor. Yeah,
you know the one I’m talking about, that big shiny one. BE REALLY SURE
IT GOES IN THE RIGHT WAY. During initial testing for this kit,
someone
soldered it in backwards, and well, there was an incident. The black band
indicates the negative lead. It’s pretty easy to solder in. The leads are big-
ger so it will take a little more solder than the teeny parts.
Okay, enough with these weenie parts. Let’s solder in the through holes.
25. Install J6 and J5, the big silver screw post things on the right side of
the board. Don’t be afraid to use enough solder to hold them in well.
26. Install J7, the green three terminal block thingy at the bottom of the
board.
27. Install J4, the power jack, lower left of the board. Be sure to use
enough solder.
28. Install J1 and J2, the two pin headers at the upper right left of the
board.
29. Install, wait, uh, I guess that’s it! Now it’s testing time.
