Ramsey Electronics FM100B, Instruction Manual

Page: 41 / 56

FM100B
•
41
12I. Install J3, the four pin Molex connector. This is where the +-12VDC is
plugged in from our power supply.
13I. Install J2, the other 4-pin MOLEX connector. This is where the 85-
264VAC is plugged in from the line cord.
14I. Install J6, the stereo RCA jack module. Make sure and mount this so
the back is square in relation to the PC board and that the jack is mounted
flush to the PC board.
That takes care of all of the jacks and switches. Now we want to give the unit
a thorough check over with the most picky eye that you possess (right or left
eye, it’s up to you). We have installed quite a few parts up to this point and
chances are you may have made a mistake somewhere along the line. Even
the best kit assemblers are known to make mistakes when putting their kits
together. Avoid simple mistakes like a solder bridge or a part installed
backwards (whoops!) by just simply looking over the boards for obvious
errors. We just want to make sure you don’t need to send back the unit for
something that could be easily found and repaired on your own. To assist you
in checking your project out, have an associate check your work for you. You
may be surprised what they can point out for you!